What Are The Effects of Contact with Water After Long-term Work of The Chamber Filter Press?

The chamber filter press is an important equipment for sludge separation. Due to the special working environment, the chamber filter press may be in contact with water for a long time. What are the effects of contact with water after long-term work? After long-term water erosion, the control system of the chamber filter press is greatly damaged. The control system of the chamber filter press includes a large number of circuit systems and various complex electronic components, which are afraid of being eroded by water.

The long-term continuous water damage to the chamber filter press is caused by a short circuit in the control system of the chamber filter press, which can cause the circuit to burn and damage to various electronic components. This may lead to more serious consequences. When the control system is corroded by water, it may cause the sensing end of the control system to slow down, and the equipment allows the wrong operating procedure, which may cause destructive damage to the tank filter, but may also cause casualties.

The hydraulic system of the chamber filter press, especially the hydraulic system of the chamber filter press, can also cause damage. We focus on damaging the hydraulic oil. The hydraulic oil is stored in the hydraulic station. It has been eroded by water for a long time. The water will slowly mix with the oil, and the hydraulic pump will be pumped and run on the oil body. Therefore, the speed of the hydraulic oil and water is further mixed and accelerated. When the oil molecules are filled with a large amount of water molecules, the hydraulic oil will slowly emulsify and turn white. The oil body has large molecules and molecular gaps. Under pressure, it is easy to change with the size of the pressure molecular gap, so the volume of the liquid will change.

The filter plate is one of the more vulnerable parts, such as the plate and frame filter press, which is one of the reasons why we often replace the filter plate. Frequent replacement of the filter plate will not only increase the economic cost, but also have a great impact on the working efficiency of the filter press. Therefore, if the filter plate can be used for a longer time, it can not only reduce the cost of the filter press, but also create greater value.

So is there a way to make the filter plate of the filter press longer?

1. Reduce direct sunlight. Since most filter press plates are made of polypropylene, although many additives are added, the oxidation degree of the filter plates is greatly reduced, but more than 80% of the filter presses are used. For the filter press, all working under harsh environments, humidity, acid and alkali erosion and other conditions are no small considerations. If combined with the catalytic effect of sunlight, the oxidation plate filter may increase by several degrees, making the plastic brittle, fragile, without a bit of flexibility, just like glass, it will break when it is touched.

2. Human operation. We hope to minimize the "fixed" work of the filter press. The "fixed" work of the filter press is inevitable. For example, when the filter press starts working again after the discharge starts, the "fixed" filter press is working, and other substances between the filter plate and the filter press pressure system also provide high-intensity pressure. When there is no material to fill, the filter plate is easy to break under pressure, causing irreparable damage to the filter plate.

3. Arrange the filter plate. When the filter press is working, a strong pressure will be applied to the filter plates. This pressure will cause a slight deformation between the filter plates and the filter plates, which will cause the filter plates to suddenly change order. Then during filtration, the plates are more likely to break. At that time, the long-term complementarity will attack each other, so we should place the filter plates in order.